Changes in 3208c77: Updated wireguard (markdown)

				howto/wireguard.md
			
          @@ -71,7 +71,7 @@ The script makes some changes that are not valid when used for DN42 tunnels, and

           - By default, the script will add a routing policy that routes the 'AllowedIP' ranges through the tunnel. In DN42, route selection is managed by BGP so the routing policy *must* be removed to avoid problems. This is achieved by adding the '_Table = off_' directive. 

          -  - Warning: a common pattern for DN42 tunnels is to use `AllowedIPs = 0.0.0.0/0` or `AllowedIPs = ::/0` then use firewall rules to limit source and destination addresses. If you do not add 'Table = off' this could cause you to route clearnet traffic via your peer and potentially lose connectivity to your node !

          +  - **Warning: a common pattern for DN42 tunnels is to use `AllowedIPs = 0.0.0.0/0` or `AllowedIPs = ::/0` then use firewall rules to limit source and destination addresses. If you do not add 'Table = off' this could cause you to route clearnet traffic via your peer and potentially lose connectivity to your node !**

           - It is common in DN42 to use Point-to-Point addressing schemes on tunnel interfaces (that is, using IPv4/32 and IPv6/128 addresses); this is not supported by wg-quick. To configure PTP addresses you must add a '_PostUp_' statement that first removes the addresses that wg-quick has configured and then re-add them. On Linux, this will typically be done using /sbin/ip.

...	...	@@ -71,7 +71,7 @@ The script makes some changes that are not valid when used for DN42 tunnels, and
71	71
72	72	- By default, the script will add a routing policy that routes the 'AllowedIP' ranges through the tunnel. In DN42, route selection is managed by BGP so the routing policy must be removed to avoid problems. This is achieved by adding the '_Table = off_' directive.
73	73
74		- - Warning: a common pattern for DN42 tunnels is to use `AllowedIPs = 0.0.0.0/0` or `AllowedIPs = ::/0` then use firewall rules to limit source and destination addresses. If you do not add 'Table = off' this could cause you to route clearnet traffic via your peer and potentially lose connectivity to your node !
	74	+ - Warning: a common pattern for DN42 tunnels is to use `AllowedIPs = 0.0.0.0/0` or `AllowedIPs = ::/0` then use firewall rules to limit source and destination addresses. If you do not add 'Table = off' this could cause you to route clearnet traffic via your peer and potentially lose connectivity to your node !
75	75
76	76	- It is common in DN42 to use Point-to-Point addressing schemes on tunnel interfaces (that is, using IPv4/32 and IPv6/128 addresses); this is not supported by wg-quick. To configure PTP addresses you must add a '_PostUp_' statement that first removes the addresses that wg-quick has configured and then re-add them. On Linux, this will typically be done using /sbin/ip.
77	77